[embedyt] https://www.youtube.com/watch?v=dfvplNWGDko[/embedyt]

Have you ever taken a second to wonder how exactly you can quickly and easy it might be to tidy up the tray of your Ute after a nightmare trip with gear strewn everywhere? We have just the ticket for not only getting your Ute tray organised, but also making everything that much easier to access when you are fully packed up and ready to camp.

Our perfect solution to your storage troubles, is to rig up a set of Titan Rear Drawers, but don’t just settle for only a pair of drawers when you can have 150% of the organised space by adding a third!

Also why just settle for the built in fridge slide (included on the double drawers) when you can have double the fridge extension, by bolting a fridge slide to the top of your drawers built-in fridge slide, this comes in handy particularly with larger volume fridges where opening can cause a bit of grief with reduced head room, doubling up your fridge slides gives you the ability to pull your fridge all the way out of your Ute canopy letting you have full access to everything inside your fridge, even stuff that is buried deep.

Getting started you need to consider the best position to mount up your Titan Rear Drawers, when you purchase a set of Titan Rear Drawers they come in the box 95% pre-assembled, which means you can simply set them in place and begin to figure out exact spacing for your setup. We’ve covered in great detail before the best way to mount your drawer chassis to the body of your ute tray, so we wont get into fine detail, but once your drawers are bolted down place the top panels into position on the top of your set of drawers.

With the top panel in place, it is time to ensure the next layer of your setup is perfectly aligned, this means your third drawer and second fridge slide. Simply set them on top of the wood top panels found on your pair of drawers and make sure everything is squared up, once you have set everything into position. Mark out the location of the Single Drawer and the location of your Adventure Kings Fridge Slide taking care to make sure the bolt holes are aligned perfectly and marking the front and rear edge of the Single drawer to make sure you fasten it to the correct positions on the tops of your twin drawers.

Once the holes for the fridge slide are marked out, simply drill through the top plate, and fasten the slide into position using fasteners and a couple of washers. With your second top plate set in a workable area, its time to mount the single drawer to the top plate, this is easy to do because your bolt holes can be marked out and the top plate fastened tightly and easily outside the vehicle.  Then simply reinstall the top plates to your double drawers and finish up your installation with tightening all the necessary fasteners.

Now with your triple drawer and supa-extended fridge slide, you wont have any trouble locating your gear on the tracks again!

to find out more about the entire range of gear available from 4WD Supacentre head to www.4WDSupacentre.com.au call us on 1800 88 39 64 or visit one of our in store locations to speak with a professional in person and figure out what the next cost effective upgrade for your setup will be!